Inspecting Garage Door Openers for Safety
The garage door is generally the largest moving object on a home. A garage door can exert very strong forces and should reverse if there is an emergency. Improperly operating automatic reversing mechanisms on garage door openers have been linked to many injuries and even deaths. Making sure the safety reverse is operating properly is an important part of your home inspection.
Modern openers have two safety reverse features on the door, which will automatically reverse the door if it encounters an obstacle upon closing. In 1982, a voluntary industry standard was created that requires an automatic reversing mechanism be part of the garage door opener. Under U.S. federal law (UL 325), garage door openers manufactured for the U.S since 1993 must also include a secondary safety reversing system, such as photoelectric eyes mounted no higher than six inches above the ground, or an electric safety edge mounted on the bottom of the door, which reverses upon contact.
Before you check the safety reverses, run the door up and down noting movement and any unusual noises, and check the tracks for any damage. Also check for loose/missing hardware on the door and tracks. Make sure you document any damaged tracks and loose/missing hardware and recommend repair by a qualified garage door professional. Identify the type of door present and the condition of the overhead door noting any damage/deterioration on the door.
Testing the safety reverse of the garage-door opener
With the door fully open, place a 2×4 flat on the floor, centered under the garage door. Do not attempt to stop the door with your hands. Operate the door in the down direction. When the door hits the board it should stop and reverse.
Testing the photoelectric eyes
Operate the door, and as the door is coming down, use a long stick to cross the path of the sensors. If operating properly, the door should stop and reverse as the stick crosses the sensors. A malfunctioning safety reverse or photoelectric eyes should be reported as a potential safety hazard.
Some other things that the home inspector should be looking for
- If the garage door has extension springs, check to see if there is a safety cable running through the center of the springs and properly secured. If not, recommend safety cables be installed.
- Look for any extension cord wiring or any wiring that wasn’t professionally installed. The garage should have a receptacle that the garage door opener can be directly plugged into.
- Check that an emergency release handle is present (red handle) and that it works by pulling down on the handle, which should detach the door from the door opener. Reset after testing.
- The transmitter (open/close button) for the garage-door opener should be mounted at least 5′ above the floor so that small children can’t reach it.