American Home Inspectors Training Institute
Call 1-800-441-9411
8am-8pm M-F & 9am-1pm Sat CST
AHIT Home About AHIT Training Products & Reports Software Members Support Contact Us
 
Members



Request your complimentary catalog today! Order Now
Follow us on Facebook
Follow us on Twitter
Become an AHIT Member

Smoke Detectors and Smoke Detector Location 

 

A properly installed and maintained smoke alarm is the only thing in your home that can alert you and your family to a fire 24 hours a day, seven days a week. Industry experts at the NFPA have determined that in a typical home fire, you only have three minutes to escape.   There are many different brands of smoke alarms available on the market, but they fall under two basic types: ionization and photoelectric. Dual sensor smoke alarms are combination smoke alarms that combine ionization and photoelectric into one unit.

Ionization smoke detection is generally more responsive to flaming fires.  Ionization-type smoke alarms have a small amount of radioactive material between two electrically charged plates, which ionizes the air and causes current to flow between the plates. When smoke enters the chamber, it disrupts the flow of ions, thus reducing the flow of current and activating the alarm. Sources of these fires may include flammable liquids or paper burning in a waste container. Most smoke alarms in use are of this type.

A photoelectric type smoke alarm consists of a light emitting diode and a light sensitive sensor in the sensing chamber. The presence of suspended products of combustion in the chamber scatters the light beam. This scattered light is detected and sets off the alarm. Sources of these fires may include cigarettes burning in couches or bedding.

Placement of smoke detectors is also very important.  Home inspectors should be aware that according to the IRC 2009 smoke detectors should be installed in each sleeping room, outside each separate sleeping area in the immediate  vicinity of the bedrooms and on each additional story of the dwelling , including basements and habitable attics but not including crawl spaces and uninhabitable attics.   In new construction, minimum requirements are typically more stringent. All smoke detectors must be hooked directly to the electrical wiring, be interconnected and have a battery backup.

If the smoke alarm is battery powered, it will run on either a disposable 9-volt battery or a non-replaceable 10-year lithium battery.  These batteries must be tested on a regular basis and, in most cases should be replaced at least once each year (except for lithium batteries).

Back to Home Inspection Industry News >>